Creating a curved edge between the arc and the vertical line

The initial steps we have to do, start SolidWorks and open a new part.

Select the Front Plane and sketching.

Make a sketch of the line consisting of four rows and three dimensions.

Make sure the lower left corner of the sketch is the origin.

Click on the Arc in the CommandManager.

Click on the Arc Tangent in the PropertyManager.

Click on the right end of the horizontal line above.

Place the tip of the arc at the tip end of a horizontal line above.

Press the button to end the command line.

Set the dimensions for the bow that we just created

Click on the Smart dimension in-Command Manager.

Create a dimension for each line of 60, 30, 20

Click on the arc.

Set dimensions.

Create an arc radius to 65.

Click on OK.

Creating a curved edge between the arc and the vertical line.

Click on the Sketch Fillet CommandManager.

Create a radius of 10 mm 'in the Property Manager-.

Click on the bow, to the left of the vertical line.

Click on the vertical line, just below the arc.

Click on OK.

Click Features in CommandManager and Revolved Boss / Base

Next, we must set the axis of rotation:

Click on the left vertical line in the sketch.

Make sure the angle of rotation of the Property Manager is set to '360-degree '.

Click on OK.

READ MORE.......

for STEP BY STEP GUIDE solidwork simple tutorial please visit.........

www.solidworksimpletutorial.blogspot.com

---or---

www.solidwork-simple-tutorial.com

Berbagi :