section view SOLIDWORKS

With Solidworks, we can see the inside of an design by cutting off the view with section lines.
To make the section view:
Click on the section view in the Drawing toolbar, or click Insert, Drawing
View, Section.
Section View PropertyManager appeared, and the Line tool is active.
To create the look of a multi-line, or using the line the middle as the line sections, sketch the line before clicking the tool
Section View. Some of the lines can have the same label.
A warning message will appear if the standard image that we use does not allow it.
If the line does not fully penetrate the bounding box of model in view, we are asked whether we want this to be partial cut. If you click Yes, See Section made as part of partial view

Read more........

Berbagi :