Dome SOLIDWORKS

Here we will learn to create a dome, Dome We can create one or more features simultaneously on the same model.

Parameters in the PropertyManager Dome include face to the Dome. Select planar face or non-planar.

We can apply the Dome to face the centroid lies outside the face.

This allows you to apply the Dome for an irregular contour.

We must set a value for the distance where the Dome expands.

Opposite direction. Click to create a default Dome dome is concave to convex.

Dome Control feature by selecting a sketch that contains the point to restrict the form of sketches.

When we use a sketch that contains points as constraints, Distance disabled.

Click the Direction, and select the direction of the vector graphics to drive the Dome in directions other than normal to the face. As a vector direction, we can use the advantages of linear or vector sketches made ​​by two points.

On the cylinder and cone models, we can set the distance to 0.

The software calculates the distance by using the radius arc as the basis for the Dome.

This will create a dome that intersect with the face of an adjacent cylinder or cone.

Steps we need to do in making the Dome is

Dome Click on the toolbar feature, or click Insert, Features, Dome.

Click OK.

Read more........

Berbagi :